What’s Included In Our Heater Tune-Up

Your heating and cooling system is a complex piece of machinery that gets dirty, wears down, needs lubrication, and requires calibration. Here is what we do to refresh it:

The 18-Point Check-Up

  • Test system for carbon monoxide
  • Test for gas leaks
  • Test ignition system for safe and proper operation
  • Test safety and control circuits
  • Inspect duct system and airflow
  • Inspect for combustible material around furnace
  • Wash or replace standard 1 inch filter
  • Visually inspect heat exchanger for separations
  • Tighten and inspect all electrical wiring
  • Test exhaust system for proper venting
  • Measure amperage and voltage of motors
  • Measure and adjust gas pressure for peak efficiency
  • Clean and lubricate blower assembly
  • Brush, clean, and vacuum burner compartments
  • Measure Supply/Return temperature differential
  • Calibrate and level thermostat
  • Clean furnace exterior
  • Inspect Secondary Motor Control